Switch Settings for 3xxxx Digitizer with CADkey

A.   Configure the Digitizer.

     1.   Use the pointing device to click on the CONFIG/EXIT key on the tablet menu strip using the pick button on the
           pointing device.  The CONFIGURATION light on the digitizer should turn on.

     2.   Click on the Bank A key.

     3.   As you place the pointing device on each button of the tablet 1 through 18, the POWER light will be either on or
          off. You can toggle the setting of any button by pressing the pick button.   The settings should be as follows:

          Bank A-0  1  0  0  0  1  1  1  1  1  0   0  0  1  1  1  0  1

          Bank B-0  0  1  1  0  0  0  0  0  0  0   0  0  0  0  0  0  1

          (1=POWER light on      0=POWER light off)

     4.   Click on the SAVE DEFAULT key to save these settings as the power-on default.

     5.   Click on the CONFIG/EXIT key to EXIT the CONFIGURATION.  The CONFIGURATION light on the digitizer
           should turn off.

     6.   Start C Map and follow the instructions in the application manual to configure C Map for use with the CalComp
           3xxxx series digitizer setup as a CalComp 9100 Format #4.