Switch Settings for 3xxxx Digitizer with 3D Studio

Autodesk
2320 Marinship Way
Sausalito, CA  94965
Contact Authorized Dealer for Assistance

A.   Configure the Digitizer.

     1.   Use the pointing device to click on the CONFIG/EXIT key on the tablet menu strip using the pick button on the
          pointing device.  The CONFIGURATION light on the digitizer should turn on.

     2.   Click on the Bank A key.

     3.   As you place the pointing device on each button of the tablet 1 through 18, the POWER light will be either on or
          off. You can toggle the setting of any button by pressing the pick button.   The settings should be as follows:

          Bank A-1  1  0  0   0  1  1  1  1  1  0  1  0  1  1   1  0  1

          Bank B-0  0  1  1   0  0  0  0  0  0  0  0  0  0  0   0  0  1

           (1=POWER light on      0=POWER light off)

     4.   Click on the SAVE DEFAULT key to save these settings as the power-on default.

     5.   Click on the CONFIG/EXIT key to EXIT the CONFIGURATION.  The CONFIGURATION light on the digitizer
           should turn off.

     6.   Start 3D Studio and follow the instructions in the application manual to configure 3D Studio for use with the
          CalComp 3xxxx series digitizer setup as a GTCO DP5.